AC PRODUCTS INC.

The Universal Sealant
FLEXIBLE SEAL


FLEXIBLE SEAL IS A SINGLE COMPONENT, PAINTABLE, ELASTOMERIC SEALANT PRIMARILY DESIGNED FOR USE IN THE SEALING OF SMALL JOINTS OR CRACKS (UP TO 1/4"). IT IS ALSO USED TO RESIST WATER AND WEATHER ELEMENTS ON RESIDENTIAL AND COMMERCIAL ROOFS.

BENEFITS:
  • Seals Damp Surfaces
  • Gunnable to -20F
  • Long-Term Service Life
  • Excellent Adhesion
  • 800% Aged Elongation
  • Paintable
  • No Primer Needed
  • Mildew & Fungus Resistant
  • Alkaline & Acid Stable
  • Resticks
  • Low Dirt Pick-Up
  • Excellent Low-Temp Flexibility
  • Asphalt Compatible

COLORS/QUANTITY AVAILABLE:
  • Clear, White, Gray, Black, Walnut Brown, Cedar and Almond.
  • 10.6 fluid ounces per disposable cartridge.
    (25 cartridges per case)

APPLICATION:
  • Apply to either a dry area or a damp surface.
  • Joint depth: Not to exceed 1/4 inch.
  • Joint width: Not to exceed 1/4 Inch.
  • Tooling and smoothing: Use Xylol or TARP SOLVENT. (use only closed cell back-up materials.)

CAUTION:
  • Material must breathe to fully cure.
  • Do not use in contact with solvents.
  • Do not use where extreme abrasion is expected.
  • Keep away from heat, sparks and open flame: contains toluol.
  • Apply above -20F (-29C) for ease of gunnability.
PROPERTIES:
Physical Property Typical Test Result
Adhesion to most substrates Excellent
Appearance Viscous Gel
Shelf Stability 2 years
Gunnability Excellent
Slump or Sag (1/4" bead) None on vertical surfaces
Tack-free time 30-60 minutes

FULLY CURED MATERIAL:
Physical Property Method of Test Typical Result
Accelerated weathering 2000 hrs ASTM G-53-77 No cracking, or adhesion loss. Remains flexible.
ADHESION
Steel 40# PLI
Glass 50# PLI
Aluminum 28# PLI
Concrete 50# PLI
Wood 50# PLI
Red Brick 50# PLI
Tensile at 75F ASTM D-2370 600 psi
Elongation at 75F ASTM D-2370 800%
Recovery at 300% 90%
Paintable Yes
Fungus Resistance Fed. T.M. STD. No. 6271 passes


Back to FlexSeal Main Page



The information herein is believed to be reliable, but unknown risks may be present. Accordingly, buyer assumes all risks whatsoever as to the use o1 these materials and Buyer's exclusive remedy as to any breach of warranty claim shall be limited to the replacement of necessary sealant for repair al no charge to Buyer. Failure to strictly adhere to recommended procedures shall relieve TECHNICAL COATINGS INTERNATIONAAL INC. of all liability with respect to the materials or the use thereof.